ETM PRO
- Prevents freezing of pipes and lines
- Plug & Play
- Automatic on and off due to build in thermostat
- The thermostat is housed in a robust potting sleeve with a unique design for optimal positioning on the pipe
- Simple installation
- Rated voltage 230 VAC
- Two-wire heating cable with 15 W/m
The ETM PRO frost protection heating cable is a plug-in heating circuit based on a two-wire heating cable. The heating cable compensates for the heat loss at the pipe that occurs during the cold season and thus reliably prevents the pipe from freezing and protects it from damage. This extends the service life of the pipe and reduces repair and operating costs. Via the bimetal thermostat installed in the connection muff, the heating circuit switches on automatically at +3 °C and off again at +12 °C, depending on the workpiece temperature.
The ETM PRO heating circuit consists of a fixed resistance heating cable with a UV-resistant polyolefin outer sheath and is equipped with a PTC thermistor (2m length) with plug, a connection sleeve with integrated bimetal thermostat and an end termination. The factory-made, cast connection muff e and the end termination are reliably and tightly sealed.
The sheathing with aluminium tape with 100 % coverage inside the cable provides additional mechanical strength and, together with a copper by-wire, serves as an earthing measure for safe operation.
Installation method
Tubes & Pipes
Gutter
Open (UV-resistant)
Technical Data
Rated voltage
Nom. power output
Switch-on temperature
Switch-off temperature
Minimum storage temperature
Minimum installation temperature
Minimum bending radius
Cold lead length
Heating cable diameter
IP protection class
Heating cable colour
Mechanical class
Certifications
230 VAC
15 W/m
+3 °C
+12 °C
-30°C
-10°C
2 m
ca. 6mm
IPX7
blue
M2 (according to IEC 60800)
CE, RoHS