EcoPRO Heating Mat

The ultra-thin EcoPRO heating mat can be used both as direct heating and as a supplementary heating system for improved thermal comfort. Due to its low installation height, it can easily be embedded in a thin layer of tile adhesive. The system can be used under a wide variety of floor coverings, e.g. under tiled, natural stone or carpeted floors. It is suitable for all types of rooms and can be used in both new and old buildings.

Even heat emission over the large floor area ensures an ideal room climate with little air and dust circulation and thus offers a healthy climate, especially for allergy sufferers. By installing the heating mat directly under the floor covering, the room temperature can be regulated quickly and efficiently.

For energy-saving operation of the EcoPRO heating mat, an electronic temperature controller with a corresponding floor temperature sensor must be installed. The floor sensor must be positioned in a cable conduit (empty conduit). The sensor must be positioned directly under the heating mat by prising open a slot in the floor and sinking the empty pipe into it.

The sensor should be positioned centrally between two heating cables, i.e. in the middle of a heating cable loop. The thermostat should be mounted on the wall in the same room where the heating is installed. The applicable standards and regulations as well as the installation manuals must be observed.

Installation method

Primary Heater

Comfort Heater

Tile adhesive layer

Leveling compound

Technical Data

Rated voltage

Nom. power output

Maximum operation temperature

Minimum operation temperature

Minimum storage temperature

Minimum installation temperature

Installation width

Cold lead length

Heating cable diameter

IP protection class

Heating cable colour

Fiberglass mesh colour

Certifications

230 VAC

100, 150, 160, 200 W/m²

+80°C

-15°C

-30°C

0°C

0,5m

3m

ca. 3,2mm

IPX7

Grün

Grau

CE, VDE

Downloads

Contact us

i-warm GmbH

i-Park Tauberfranken 18 – 20

97922 – Lauda-Königshofen

info@i-warm.de